پیوندهای مفید
اخبار و اعلانات
آمار
| تعداد نشریات | 161 |
| تعداد شمارهها | 6,532 |
| تعداد مقالات | 70,501 |
| تعداد مشاهده مقاله | 124,115,744 |
| تعداد دریافت فایل اصل مقاله | 97,220,035 |
The Influence of thermal breakage on physio-mechanical behavior of Ghulmet marble north Pakistan | ||
| International Journal of Mining and Geo-Engineering | ||
| مقاله 12، دوره 56، شماره 2، شهریور 2022، صفحه 199-203 اصل مقاله (550.22 K) | ||
| نوع مقاله: Research Paper | ||
| شناسه دیجیتال (DOI): 10.22059/ijmge.2021.318906.594891 | ||
| نویسندگان | ||
| Naeem Abbas* 1؛ Kegang Li2؛ Asghar Khan3؛ Javed Akhter Qureshi3 | ||
| 1Department of Mining Engineering, Karakoram International University (KIU), Gilgit, Pakistan | ||
| 2Faculty of Land Resource Engineering, Kuming University of Science and Technology, Kunming, Yunnan, China | ||
| 3Department of Earth Sciences, Karakoram International University (KIU), Gilgit, Pakistan | ||
| چکیده | ||
| Geotechnical engineering applications comprises high temperature such as deep geological disposal of nuclear waste, exploitation of geothermal process, etc. High temperature and thermal environments can affect the mechanical properties of building materials used in civil engineering (concrete, building rock, steel, etc.). The constant action of regular thermal changes in situations of excess temperature is the main source of the alteration of marble in monumental and artistic buildings. In this study, the effect of both the specimen size and temperature on the physio-mechanical characteristics of dolomitic marble has been investigated. The temperature range selected was 20-600°C. It was observed that the color of samples changes with temperature rise. The Uniaxial compression strength (UCS), P-wave velocity (Vp), and Young’s modulus decreased with temperature rise. While the peak strain increases with temperature. The UCS and the peak strain showed a decreasing trend at the high diameter specimens. In the case of 43mm diameter specimens the peak stress reduced from 60MPa-26MPa with a rise in temperature from 20-600°C. While at the same temperature range the peak strain was observed as 1.7-3.3 and Young’s modulus was 34-8GPa. For 75mm diameter, the peak stress is reduced to 17MPa when the temperature rises to 600°C and Young’s modulus decreased to 4GPa while the peak strain increased from 2.3 to 3.9. The pulse velocity decreased from 2.75 km/s to 0.8km/ and the porosity value increased from 0.9 to 1.5%. | ||
| کلیدواژهها | ||
| Temperature؛ Specimen size؛ Uniaxial compressive strength؛ P-wave velocity؛ Stress | ||
| مراجع | ||
|
[1] Raoof, S.M. and D.A. Bournas, Bond between TRM versus FRP composites and concrete at high temperatures. Composites Part B: Engineering, 2017. 127: p. 150-165.
[2] Chang, S.-H., S.-W. Choi, and J. Lee, Determination of the combined heat transfer coefficient to simulate the fire-induced damage of a concrete tunnel lining under a severe fire condition. Tunnelling and Underground Space Technology, 2016. 54: p. 1-12.
[3] Najafi, M., S.M.E. Jalali, and R. KhaloKakaie, Thermal–mechanical–numerical analysis of stress distribution in the vicinity of underground coal gasification (UCG) panels. International Journal of Coal Geology, 2014. 134: p. 1-16.
[4] Simmons, G. and H.W. Cooper. Thermal cycling cracks in three igneous rocks. in International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts. 1978. Elsevier.
[5] Sprunt, E.S. and W. Brace. Direct observation of microcavities in crystalline rocks. in International Journal of Rock Mechanics and Mining Sciences & Geomechanics Abstracts. 1974. Elsevier.
[6] Yavuz, H., S. Demirdag, and S. Caran, Thermal effect on the physical properties of carbonate rocks. International Journal of Rock Mechanics and Mining Sciences, 2010. 47(1): p. 94-103.
[7] Tian, H., M. Ziegler, and T. Kempka, Physical and mechanical behavior of claystone exposed to temperatures up to 1000 C. International Journal of Rock Mechanics and Mining Sciences, 2014. 70: p. 144-153.
[8] Hettema, M., D. Niepce, and K.-H. Wolf, A microstructural analysis of the compaction of claystone aggregates at high temperatures. International Journal of Rock Mechanics and Mining Sciences, 1999. 36(1): p. 57-68.
[9] Peng, J., et al., Physical and mechanical behaviors of a thermal-damaged coarse marble under uniaxial compression. Engineering Geology, 2016. 200: p. 88-93.
[10] Rodríguez-Gordillo, J. and M. Sáez-Pérez, Effects of thermal changes on Macael marble: Experimental study. Construction and Building Materials, 2006. 20(6): p. 355-365.
[11] Luque, A., et al., Direct observation of microcrack development in marble caused by thermal weathering. Environmental Earth Sciences, 2011. 62(7): p. 1375-1386.
[12] Plevová, E., et al., Thermal behavior of selected Czech marble samples. Journal of thermal analysis and calorimetry, 2010. 101(2): p. 657-664.
[13] Liu, S. and J. Xu, Analysis on damage mechanical characteristics of marble exposed to high temperature. International Journal of Damage Mechanics, 2015. 24(8): p. 1180-1193.
[14] Lion, M., F. Skoczylas, and B. Ledésert, Effects of heating on the hydraulic and poroelastic properties of bourgogne limestone. International Journal of Rock Mechanics and Mining Sciences, 2005. 42(4): p. 508-520.
[15] Fredrich, J.T. and T.f. Wong, Micromechanics of thermally induced cracking in three crustal rocks. Journal of Geophysical Research: Solid Earth, 1986. 91(B12): p. 12743-12764.
[16] Mahmutoğlu, Y., The effects of strain rate and saturation on a micro-cracked marble. Engineering Geology, 2006. 82(3): p. 137-144.
[17] Vagnon, F., et al., Effects of thermal treatment on physical and mechanical properties of Valdieri Marble-NW Italy. International Journal of Rock Mechanics and Mining Sciences, 2019. 116: p. 75-86.
[18] Yao, M., et al., Effects of thermal damage and confining pressure on the mechanical properties of coarse marble. Rock Mechanics and Rock Engineering, 2016. 49(6): p. 2043-2054.
[19] Rong, G., et al., Effects of specimen size and thermal-damage on physical and mechanical behavior of a fine-grained marble. Engineering Geology, 2018. 232: p. 46-55.
[20] Ahmed, K., et al., Mechanical, swelling, and thermal aging properties of marble sludge-natural rubber composites. International Journal of Industrial Chemistry, 2012. 3(1): p. 1-12.
[21] Yavuz, A. and T. Topal, Thermal and salt crystallization effects on marble deterioration: examples from Western Anatolia, Turkey. Engineering geology, 2007. 90(1-2): p. 30-40.
[22] Guo, Q., et al., An experimental study on the fracture behaviors of marble specimens subjected to high temperature treatment. Engineering Fracture Mechanics, 2020. 225: p. 106862.
[23] Zhu, Z.-n., et al., Effects of high temperature on the mechanical properties of Chinese marble. Rock Mechanics and Rock Engineering, 2018. 51(6): p. 1937-1942.
[24] Tang, Z.C., M. Sun, and J. Peng, Influence of high temperature duration on physical, thermal and mechanical properties of a fine-grained marble. Applied Thermal Engineering, 2019. 156: p. 34-50.
[25] Fiore, V., et al., Effect of plasma treatment on mechanical and thermal properties of marble powder/epoxy composites. Polymer Composites, 2018. 39(2): p. 309-317.
[26] Ghada, B., et al., Effect of marble powder and dolomite on the mechanical properties and the thermal stability of poly (vinyl chloride). Asian Journal of Chemistry, 2010. 22(9): p. 6687.
[27] Ulusay, R., The ISRM suggested methods for rock characterization, testing and monitoring: 2007-2014. 2014: Springer.
[28] Gaetani, M., Blank on the geological map. Rendiconti Lincei, 2016. 27(2): p. 181-195.
[29] Hungr, O., S. Leroueil, and L. Picarelli, The Varnes classification of landslide types, an update. Landslides, 2014. 11(2): p. 167-194.
[30] Peng, J., et al., A model for characterizing crack closure effect of rocks. Engineering Geology, 2015. 189: p. 48-57.
[31] Seifert, W.K. and J.M. Moldowan, The effect of thermal stress on source-rock quality as measured by hopane stereochemistry. Physics and Chemistry of the Earth, 1980. 12: p. 229-237.
[32] Cai, X., et al., Water saturation effects on thermal infrared radiation features of rock materials during deformation and fracturing. Rock Mechanics and Rock Engineering, 2020. 53(11): p. 4839-4856.
[33] Su, H., et al., Effect of thermal environment on the mechanical behaviors of building marble. Advances in Civil Engineering, 2018. 2018. | ||
|
آمار تعداد مشاهده مقاله: 408 تعداد دریافت فایل اصل مقاله: 290 |
||