فرایند کشش عمیق استوانه‌های با نسبت کشش خیلی بالا

	فرایند کشش عمیق استوانه‌های با نسبت کشش خیلی بالا
Journal of Algorithms and Computation
مقاله 16، دوره 43، شماره 4، آذر 2009، صفحه 519-525 اصل مقاله (278.72 K)
نوع مقاله: Research Paper
شناسه دیجیتال (DOI): 10.22059/jac.2013.7715
نویسندگان
Ghader Faraji؛ Mohammad Kazem Besharati Givi^* ؛ Saeed Yarmohammadi؛ Mahmoud Mousavi Mashhadi
چکیده
Deep drawing of cylindrical shapes with high limiting drawing ratio (LDR) values is relatively difficult. Annealing is a further operation, which in turn adds costs and consumes significantly time to the forming process. In the present work, cylindrical cups from brass sheet were made with only limited anneal during few steps, but having LDR of 9 that is about 2 times higher than previous works. Cups having 4 mm IDs and 70 mm heights were made successfully. The process was simulated by ABAQUS/Explicit finite element (FE) code and experimental tests were carried out based on FEM results. Parameters affecting the process were studied with experimental results, as well as FEM. The wall thickness obtained from the approach were compared for several tests, and verified significantly.
کلیدواژه‌ها
Extra High Limiting Drawing Ratio؛ FEM؛ Deep Drawing؛ Experiment

آمار تعداد مشاهده مقاله: 1,391 تعداد دریافت فایل اصل مقاله: 941

سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب