پیوندهای مفید
اخبار و اعلانات
آمار
| تعداد نشریات | 161 |
| تعداد شمارهها | 6,573 |
| تعداد مقالات | 71,037 |
| تعداد مشاهده مقاله | 125,523,835 |
| تعداد دریافت فایل اصل مقاله | 98,783,930 |
Upper Bound Solution for the Stability of Surcharged Soil Slope Using Nonlinear Failure Criterion | ||
| Civil Engineering Infrastructures Journal | ||
| مقاله 10، دوره 57، شماره 1، شهریور 2024، صفحه 175-188 اصل مقاله (706.66 K) | ||
| نوع مقاله: Research Papers | ||
| شناسه دیجیتال (DOI): 10.22059/ceij.2023.353469.1900 | ||
| نویسندگان | ||
| Mohammad Mahdi Aminpour1؛ Mohammad Maleki* 2 | ||
| 1Ph.D., Civil Engineering Department, Bu-Ali Sina University, Hamedan, Iran. | ||
| 2Associate Professor, Civil Engineering Department, Bu-Ali Sina University, Hamedan, Iran. | ||
| چکیده | ||
| In this paper using the upper bound limit analysis method, the stability of soil slope, uniformly surcharged at the crest is investigated. According to the soil behavior at the failure state, a continuous failure criterion nonlinear function of confining stress, and soil initial density is considered. The stress field along the slip surface is entered into the limit analysis formulation according to the Airy stress function. The ultimate uniformly distributed load is obtained by optimizing the virtual work equation. The effects of different parameters such as slope angle, soil unit weight, and initial density are investigated. Considering the nonlinear effects of confining stresses leads to a reduction in the ultimate load. This reduction is more obvious in slopes with lower angles. According to the proposed formulation, with increasing soil density, the ultimate load of the slope stability is increased. The results for different slope angles are compared with those obtained from the limit equilibrium-based methods. The ultimate loads of the proposed method are in some cases lower and in some cases more than the results of different methods based on limit equilibrium. | ||
| کلیدواژهها | ||
| Airy Stress Function؛ Nonlinear Failure Criterion؛ Slope Stability؛ Upper Bound Limit Analysis Method | ||
| مراجع | ||
|
Aminpour, M.M., Maleki, M. and Ghanbari, A. (2017). “Investigation of the effect of surcharge on behavior of soil slopes”, Geomechanics and Engineering, 13(4), 653-669, https://doi.org/10.12989/gae.2017.13.4.653.
Aminpour, M.M., Maleki, M. and Ghanbari, A. (2018), “Predicting seismic permanent displacement of soil walls under surcharge based on limit analysis approach”, Earthquake Engineering and Engineering Vibration, 17(4), 747-759, https://doi.org/10.1007/s11803-018-0473-6.
Aminpour, M.M. and Maleki, M. (2022). “Finite Element limit analysis using nonlinear continuous failure criterion and non-associated flow rule and its application to estimating bearing capacity of strip footing on slope", Geotechnical and Geological Engineering, 40, 723-734.
Baker, R. (2004). “Nonlinear Mohr envelopes based on triaxial data”, Journal Geotechnial and Geoenvironmental Engineering, 130(5), 498-506, https://doi.org/10.1061/(ASCE)1090-0241(2004)130:5(498).
Bathayian, M.H. and Maleki, M. (2018). “Adaptation of an existing constitutive model for describing mechanical behaviour of cemented granular soils”, Geomechanics and Geoengineering an International Journal, 13(3), 184-197, https://doi.org/10.1080/17486025.2018.1434243.
Cambou, B., Jafari, K. and Elamrani, K. (1989). “An elastoplastic model for granular material using three yielding mechanisms”, Numerical Models in Geomechanics, NUMOG III, Proceedings of the 3rd International Symposium, Niagara Falls, Canada, (pp. 149-167).
Chen, W.F. (1975). Limit analysis and soil plasticity, Elsevier Science, Amsterdam, Netherlands.
Froutan Kalourazi, A., Izadi, A. and Jamshidi Chenari, R. (2019). “Seismic bearing capacity of shallow strip foundations in the vicinity of slopes using the lower bound finite element method”, Soils and Foundations, 59(6), 1891-1905, https://doi.org/10.1016/j.sandf.2019.08.014.
Guanhua, Q. (2023). “Stability analysis of nonhomogeneous and anisotropic stepped slopes under the influence of earthquakes”, Heliyon, 9(4), e15057, https://doi.org/10.1016/j.heliyon.2023.e15057.
Haghbin, M. and Ghazavi M. (2016). “Seismic bearing capacity of strip footings on pile-stabilized slopes”, Civil Engineering Infrastructure Journal, 49(1), 111-126, https://doi.org/10.1061/(ASCE)GM.1943-5622.0002530.
Hajiazizi, M., Kilanehei, P. and Kilanehei, F. (2018). “A new method for three-dimensional stability analysis of earth slopes”, Scientia Iranica, 25(1), 129-139, https://doi.org/10.24200/sci.2017.4173.
Hajiazizi, M., Mazaheri, A.R. and Orense, R.P. (2018). “An analytical approach to evaluate stability of pile-stabilized slope”, Scientia Iranica, 25(5), 2525-2536, https://doi.org/10.24200/sci.2017.4218.
Hajiazizi, M. and Nasiri, M. (2019). “Experimental and numerical investigation of reinforced sand slope using geogird encased stone column”, Civil Engineering Infrastructures Journal, 52(1), 85-100, https://doi.org/10.22059/ceij.2019.253069.1468.
Hu, L., Takahashi, A. and Kasama, K. (2022). “Effect of spatial variability on stability and failure mechanisms of 3D slope using random limit equilibrium method”, Soils and Foundations, 62(6), 101225, https://doi.org/10.1016/j.sandf.2022.101225.
Komasi, M. and Beiranvand, B. (2021). “Seepage and stability analysis of the Eyvashan Earth Dam under drawdown conditions”, Civil Engineering Infrastructures Journal, 54(2), 205-223, https://doi.org/10.22059/ceij.2020.293429.1634.
Liu, M.D. and Carter, J.P. (2003). “General strength criterion for geomaterials”, International Journal of Geomechanics, 3(2), 253-259, https://doi.org/10.1061/(ASCE)1532-3641(2003)3:2(253).
Maleki, M., Dubujet, Ph. and Cambou, B. (2000). “Modélisation Hierarchisée du comportement des sols”, Revue Francais de Genie Civil, 4(7-8), 895-928, https://doi.org/10.1080/12795119.2000.9692702.
Mirzazadeh, Z. and Hajiazizi, M. (2020). “Determination of creep-induced displacement of soil slopes based on LEM”, Civil Engineering Infrastructures Journal, 53(2), 341-358, https://doi.org/10.22059/ceij.2020.285244.1598.
Mofidi Rochi, J., Farzaneh, O. and Askari, F. (2014). “Bearing capacity of strip footings near slopes using lower bound limit analysis”, Civil Engineering Infrastructures Journal, 47(1), 89-109, https://doi.org/10.7508/CEIJ.2014.01.007.
Qin, C. and Chian, S.C. (2017). “Kinematic stability of a two-stage slope in layered soils”, International Journal of Geomechanics, 17(9), https://doi.org/10.1061/(ASCE)GM.1943-5622.0000928.
Qin, C. and Chian, S.C. (2018). “Bearing capacity analysis of a saturated non-uniform soil slope with discretization-based kinematic analysis”, Computers and Geotechnics, 96, 246-257, https://doi.org/10.1016/j.compgeo.2017.11.003.
Razali, I.H., Taib, A.M., Rahman, N.A., Abang Hasbollah, D.Z., Mohd Firdaus Md Dan, M.F., Ramli, A.B. and Ibrahim, A. (2023). “Slope stability analysis of riverbank in Malaysia with the effects of vegetation”, Physics and Chemistry of the Earth, Parts A/B/C, 129, 103334, https://doi.org/10.1016/j.pce.2022.103334.
Sadd, M.H. (2009). Easticity: Theory, applications and numerics, 2nd Edition, Elsevier, Academic Press, Burlington, MA, USA, Oxford, UK.
Shukla, R.P. and Jakka R.S. (2018). “Critical setback distance for a footing resting on slopes under seismic loading”, Geomechanics and Engineering, 15(6), 1193-1205, https://doi.org/10.12989/gae.2018.15.6.1193.
Sun, Y. and Song, E. (2016). “Active earth pressure analysis based on normal stress distribution function along failure surface in soil obeying nonlinear failure criterion”, Acta Geotechnica, 11(2), 255-268, https://doi.org/10.1007/s11440-015-0390-z.
Tang, G., Zhao, L., Li, L. and Yang, F. (2015). “Stability charts of slopes under typical conditions developed by upper bound limit analysis”, Computers and Geotechnics, 65, 233-240, https://doi.org/10.1016/j.compgeo.2014.12.008.
Thomas, J., Gupta, M. and Prusty, G. (2023). “Assessing global parameters of slope stability model using Earth data observations for forecasting rainfall, Induced shallow landslides”, Journal of Applied Geophysics, 212, 104994, https://doi.org/10.1016/j.jappgeo.2023.104994.
Tozato, K.J., Dolojan, N.L., Touge, Y., Kure, S., Moriguchi, S., Kawagoe, S., Kazama, S. and Terada, K. (2022). “Limit equilibrium method-based 3D slope stability analysis for wide area considering influence of rainfall”, Engineering Geology, 308, 106808, https://doi.org/10.1016/j.enggeo.2022.106808.
Tran, A.T.P., Kim, A.R. and Cho, G.C. (2019). “Numerical modeling on the stability of slope with foundation during rainfall”, Geomechanics and Engineering, 17(1), 109-118, https://doi.org/10.12989/gae.2019.17.1.109.
Vo, T. and Russell, A.R. (2017). “Stability charts for curvilinear slopes in unsaturated soils”, Soils and Foundations, 57(4), 543-556, https://doi.org/10.1016/j.sandf.2017.06.005.
Wu, S., Zhang, S., Guo, C. and Xiong, L. (2017). “A generalized nonlinear failure criterion for frictional materials”, Acta Geotechnica, 12(6), 1353-1371, https://doi.org/10.1007/s11440-017-0532-6.
Zhou, H., Zheng, G., Yin, X., Jia, R. and Yang, X. (2018). “The bearing capacity and failure mechanism of a vertically loaded strip footing placed on the top of slopes”, Computers and Geotechnics, 94, 12-21, https://doi.org/10.1016/j.compgeo.2017.08.009.
Zhou, J. and Qin, C. (2023). “Influence of soft band on seismic slope stability by finite-element limit-analysis modelling”, Computers and Geotechnics, 158, 105396. | ||
|
آمار تعداد مشاهده مقاله: 234 تعداد دریافت فایل اصل مقاله: 484 |
||
سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب