تعداد نشریات | 161 |
تعداد شمارهها | 6,532 |
تعداد مقالات | 70,501 |
تعداد مشاهده مقاله | 124,113,529 |
تعداد دریافت فایل اصل مقاله | 97,217,315 |
Use of fine-grained soil for improvement of density and bearing capacity of aeolian sand | ||
Geopersia | ||
مقاله 3، دوره 13، شماره 2 - شماره پیاپی 22287825، بهمن 2023، صفحه 261-274 اصل مقاله (812.58 K) | ||
نوع مقاله: Research Paper | ||
شناسه دیجیتال (DOI): 10.22059/geope.2023.354435.648700 | ||
نویسندگان | ||
Akbar Cheshomi* ؛ Abolfazl Sahragard | ||
Department of Engineering Geology, College of Science, University of Tehran, Tehran, Iran | ||
چکیده | ||
The existence of vast areas covered with aeolian sand in many regions of Iran has made the use of this type of soil inevitable in engineering projects. Considering the abundance of fine-grained soil in Khuzestan plain along with the aeolian sand, it is important to investigate the effect of the addition of fine-grained soil to aeolian sand to improve its dry density and bearing capacity. In the present research, different percentages of fine-grained soil were added to aeolian sand from Khuzestan plain to determine its effect on the maximum dry density (dmax), optimum water content (opt) and California bearing ratio (CBR) of the aeolian sand and fine-grained soil mixture. It was found that an increase in the percentage of fine-grained soil increased the dmax and decreased the opt. The CBR of the soil increased under tests performed at the optimum water content and decreased under saturated conditions. The highest CBR for penetrations of 2.5 and 5 mm (CBR (2.5) and CBR (5)) when the samples were tested at an optimum water content was for the sample where the ratio of the dry weight of the fine-grained soil (WS(F)) to dry weight of the aeolian sand (WS(S)) is equal 40%. Comparison of the results of the current and previous research showed that, in areas such as the Khuzestan plain in which fine-grained soil is available, the use of such soil for improvement of aeolian sand is appropriate. | ||
کلیدواژهها | ||
Aeolian sand؛ Fine-grained soil؛ Compaction test؛ California bearing ratio؛ Dry density and optimum water content | ||
مراجع | ||
Abbasi, N., Mahdieh, M., 2018. Improvement of geotechnical properties of silty sand soils using natural pozzolan and lime. International Journal of Geo-Engineering, 9 (1): 1-12. Abu Seif, E.S., 2013. Performance of cement mortar made with fine aggregates of dune sand, Kharga oasis, Western desert, Egypt: an experimental study. Jordan Journal of Civil Engineering. 7 (3): 270-284. Abu-Zeid M.M., Baghdady, A.R., El-Etr, H.A., 2001. Textural attributes, mineralogy and prove-nance of sand dune fields in the greater Al Ain area, United Arab Emirates. Journal of Arid Environments. 48(4):475-99. Akili, W., Monismith, C.L., 1978. Permanent deformation characteristics of cement emulsion sta-bilized sand. Proceed. Association of Asphalt Paving Technologists. 47: 281-301. Al-Abdul Wahhab, H., Bayomy, F., Al-Halhouli. A., 1998. Evaluation of emulsified asphalt-treated sand for low-volume road and road bases. Transportation Research Record, No. 1106. Fourth International Conference on Low-Volume Roads, 1: 71-80. Al-Abdullah, S.F.I., 2006. An approach in improving the properties of sand dunes. Journal of Engineering. 13: 930-939. Al-Aghbari, M.Y., Dutta, R.K., 2005. Suitability of desert sand cement mixes for base courses in highway pavements. Electronic Journal of Geotechnical Engineering. 10 (D). Al-Ansary, M., Pöppelreiter, M.C., Al-Jabry, A., Iyengar S.R., 2012. Geological and physiochemical characterization of construction sands in Qatar. International Journal of Sustainable Built Environment, 1(1): 64-84. AlKarni, A., ElKholy, S.M., 2012. Improving geotechnical properties of dune sands through ce-ment stabilization. Journal of Computing Science and Engineering. 5 (1): 1-19. Al-Sanad, H.A., Ismael N.F., Nayfeh, A.J., 1993. Geotechnical properties of dune sands in Kuwait. Engineering. Geology. 34: 45-52. Al-Taie AJ., Al-Shakarchi Y.J., Mohammed A.A., 2013. Investigation of geotechnical spesifications of sand dune: a case study around Baiji in Iraq. International Journal of Advanced Research. 1(6):208-15. Arias-Trujillo, J., Matías-Sanchez, A., Cantero, B., López-Querol, S., 2020. Effect of polymer emulsion on the bearing capacity of aeolian sand under extreme confinement conditions. Construction and Building Materials, 236. 117473, https://doi.org/10.1016/j.conbuildmat.2019.117473. ASTM D422-63, 1998. Standard test method for particle-size analysis of soils. Annual Book of ASTM Standards. ASTM D854-14, 2014. Standard test methods for specific gravity of soil solids by water pyc-nometer. Annual Book of ASTM Standards. ASTM D 4318-00, 2000. Standard test methods for liquid limit, plastic limit and plasticity index of soils. Annual Book of ASTM Standards. ASTM D698-07, 2007. Standard test methods for laboratory compaction characteristics of soil using standard effort. Annual Book of ASTM Standards. ASTM D1883-16, 2016. Standard test method for california bearing ratio (CBR) of laboratorycompacted soils. Annual Book of ASTM Standards. Das B.M., 2007. Principles of foundation engineering. Toronto: Thomson. Elipe, M.G.M., Lopez-Querol, S., 2014. Aeolian sands: characterization, options of improvement and possible employment in construction - the state-of-the-art. Construction and Building Materials, 73:728-739. Eshraghi, A., Mehrnahad, H., Mokhtari, M., 2019. Study of stoneworks waste (mudstone) effects on geotechnical porperties of dune sand. Journal of New Approaches in Civil Engineering, 3(1): 21-32.(In persian). Freer-Hewish, R.J., Ghataora, G.S., Niazi, Y., 1999. Stabilization of desert sand with cement kiln dust plus chemical additives in desert road construction. Proceed.Institut. Civil Engineers - Transport 135:274 Cheshomi et al.29-36. Hazirbaba, K., 2019. Stabilization of aeolian sand with combined use of geofiber and synthetic fluid,cogent engineering. 6 (1): 28-39. Homauoni, Z.J., Yasrobi, S.S., 2011. Stabilization of dune sand with Poly Methyl Methacrylate and Polyvinyl Acetate using dry and wet. Processing, Geotechnical and Geological Engineering. 29: 571-579. Khan I.H., 1982. Soil studies for highway construction in arid zones. Engineering. Geology, 19:47-62. Lahalih, S.M., Ahmed, N., 1998. Effect of new soil stabilizers on the compressive strength of dune sand. Construction and Building Materials. 12: 321-328. Lopez-Querol, S., Arias-Trujillo, J., GM-Elipe, M., Matias-Sanchez, M., Cantero, B., 2017. Improvement of the bearing capacity of confined and unconfined cement-stabilized aeolian sand. Construction and Building Materials. 153: 374-384. Mohamedzein, Y., Al-Hashmi, A., Al-Abri, A., Al-Shereiqi, A., 2019. Polymers for stabilisation of Wahiba dune Ssands. Oman. Proc. of the Institution of Civil Engineers, Ground Improvement, 172(2): 76-84. Moosavi, K., Kalantari, B., 2011. Improving load bearing capacity of wind-blown sand using ordinary portland cement. Electronic Journal of Geotechnical Engineering, 16(Q):1267-1274. Onyejekwe, S., Ghataora, S., 2015. Soil stabilization using proprietary liquid chemical stabi-lizers: sulphonated oil and a polymer. Bulletin of Engineering Geology and the Environment. 74: 651-665. Onyejekwe, S., Ghataora, S., 2016. Stabilization of quarry fines using a polymeric additive and Portland cement. Journal of Materials in Civil Engineering. 28, 1. Padmakumar, G.P., Srinivas, K., Uday, K.V., Iyer, K.R., Pathak, P., Keshava, S.M., Singh, D.N., 2012. Characterization of aeolian sands from Indian desert. Engineering. Geology. 139- 140: 38-49. Silva, J.D.J., Júnior, O.F.S., Paiva, W., 2023. Compressive and tensile strength of aeolian sand stabilized with porcelain polishing waste and hydrated lime. Soils and Rocks an International Journal of Geotechnical and Geo environmental Engineering, https://doi.org/10.28927/SR.2023.002322. Souza Júnior, P.L., Santos Junior, O.F., Fontoura, T.B., Freitas Neto, O., 2020. Drained and un-drained behavior of an aeolian sand from Natal, Brazil. Soils and Rocks, 43(2): 263-270. Uromeihy, A., Sofian, J., Nikudel, MR., 2015. Investigation the use of nanoclays on the modifica-tion of aeolian sand. The international 3rd. Scientific Conference of the College of Science. Venda Oliveira, P.J., Costa, M.S., Costa, J.N.P., Nobre, M.F., 2015. Comparison of the ability of two bacteria to improve the behaviour of a sandy soil. Journal of Materials in Civil Engineering, 27(1), 06014025. http:// dx.doi.org/10.1061/(ASCE)MT.1943-5533.0001138. Venda Oliveira, P.J., Rosa, J.A.O., 2020. Confined and unconfined behavior of a silty sand im-proved by the enzymatic bio cementation method. Transportation Geotechnics, 24, 100400. http://dx.doi.org/10.1016/jtrgeo.2020.100400. Zandieh, A.R., Yasrobi, S.S., 2010. Study of factors affecting the compressive strength of sandy soil stabilized with polymer. Geotechnical and Geological Engineering. 28. 139-145. | ||
آمار تعداد مشاهده مقاله: 333 تعداد دریافت فایل اصل مقاله: 694 |