سامانه پشتیبانی خدمات اطلاعات

  اخبار و اعلانات

 آمار

تعداد نشریات161
تعداد شماره‌ها6,533
تعداد مقالات70,519
تعداد مشاهده مقاله124,133,868
تعداد دریافت فایل اصل مقاله97,239,979
Alijani, Somayeh, Paydar Ravandi, Ramin. (1400). Optimizing SO2 Adsorption from Flue Gas Using Microporous Polypropylene Hollow Fiber Membrane Contactor. , 55(2), 353-367. doi: 10.22059/jchpe.2021.327898.1356
Somayeh Alijani; Ramin Paydar Ravandi. "Optimizing SO2 Adsorption from Flue Gas Using Microporous Polypropylene Hollow Fiber Membrane Contactor". , 55, 2, 1400, 353-367. doi: 10.22059/jchpe.2021.327898.1356
Alijani, Somayeh, Paydar Ravandi, Ramin. (1400). 'Optimizing SO2 Adsorption from Flue Gas Using Microporous Polypropylene Hollow Fiber Membrane Contactor', , 55(2), pp. 353-367. doi: 10.22059/jchpe.2021.327898.1356
Alijani, Somayeh, Paydar Ravandi, Ramin. Optimizing SO2 Adsorption from Flue Gas Using Microporous Polypropylene Hollow Fiber Membrane Contactor. , 1400; 55(2): 353-367. doi: 10.22059/jchpe.2021.327898.1356

Optimizing SO2 Adsorption from Flue Gas Using Microporous Polypropylene Hollow Fiber Membrane Contactor

Journal of Chemical and Petroleum Engineering
مقاله 10، دوره 55، شماره 2، اسفند 2021، صفحه 353-367    اصل مقاله (1.24 M)
نوع مقاله: Research Paper
شناسه دیجیتال (DOI): 10.22059/jchpe.2021.327898.1356
نویسندگان
Somayeh Alijani* ؛ Ramin Paydar Ravandi
Energy and Environment Research Center, Niroo Research Institute, Tehran, Iran
چکیده
This study optimized the operational parameters of removing SO2 from flue gas via a polymeric hollow fiber membrane contactor (HFMC) using the response surface methodology (RSM). The distilled water and polypropylene hollow fibers were applied as the adsorbent and membrane material, respectively. Three experimental parameters were chosen as independent variables: liquid flow rate, gas flow rate, and initial SO2 concentration. The SO2 removal efficiency was significantly affected by the initial SO2 concentration. The optimal ratio of liquid-to-gas flow rate was found to be 0.25 to reach maximum separation efficiency (98.81%). The optimal value of the liquid flow rate was 33 l/h, and the optimal gas flow rate was 131 l/h. The effect of CO2 presence, module length, fibers number, temperature, and the adsorbent nature were also investigated under optimal values obtained for the ratio of liquid-to-gas flow rate. Results indicated that CO2 presence in the flue gas slightly affects SO2 removal using water as an absorbent in HFCM. Furthermore, it was indicated that the SO2 removal efficiency was a function of the flue gas temperature and number of fibers: it decreased as the temperature rose from 20 to 50°C and the fiber numbers increased from 300 to 1000. This study offers a model to predict the efficiency of SO2 removal using HFMC under different conditions and provides the ground to further explore the industrial applications of this technology.
کلیدواژه‌ها
Flue Gas؛ Membrane Contactor؛ Optimization Operational Parameters؛ RSM؛ SO2 Removal
مراجع
  1. Fioletov VE, McLinden CA, Krotkov N, Li C, Joiner J, Theys N, et al. A global catalogue of large SO2 sources and emissions derived from the Ozone Monitoring Instrument. Atmos. Chem. Phys. 2016;16(18):11497-519.
  2. Moghaddam MS, Moghaddam AZ. Performance and exhaust emission characteristics of a CI engine fueled with diesel-nitrogenated additives. Chem. Eng. Res. Des. 2014;92(4):720-6.
  3. Taylor MR, Rubin ES, Hounshell DA. Control of SO2 emissions from power plants: A case of induced technological innovation in the US. Technol. Forecast. Soc. Change. 2005;72(6):697-718.
  4. Yazdani S, Salimipour E, Moghaddam MS. A comparison between a natural gas power plant and a municipal solid waste incineration power plant based on an emergy analysis. J. Clean. Prod. 2020;274:123158.
  5. Park HH, Deshwal BR, Kim IW, Lee HK. Absorption of SO2 from flue gas using PVDF hollow fiber membranes in a gas–liquid contactor. J. Mem. Sci. 2008 2008/07/01/;319(1):29-37.
  6. Moghaddam MHS, Moghaddam MS, Khorramdel M. Numerical study of geometric parameters effecting temperature and thermal efficiency in a premix multi-hole flat flame burner. Energy. 2017;125:654-62.
  7. Kim K, Hong S, Kim J, Lee H. Preparation and performance evaluation of composite hollow fiber membrane for SO2 separation. AIChE J. 2014;60(6):2298-306.
  8. Mansourizadeh A, Ismail A. Hollow fiber gas–liquid membrane contactors for acid gas capture: a review. J. Hazard. Mater. 2009;171(1-3):38-53.
  9. Klaassen R. Achieving flue gas desulphurization with membrane gas absorption. Filtr. Sep. 2003;40(10):26-8.
  10. Kumar P, Hogendoorn J, Feron P, Versteeg G. New absorption liquids for the removal of CO2 from dilute gas streams using membrane contactors. Chem. Eng. Sci. 2002;57(9):1639-51.
  11. Yan S-p, Fang M-X, Zhang W-F, Wang S-Y, Xu Z-K, Luo Z-Y, et al. Experimental study on the separation of CO2 from flue gas using hollow fiber membrane contactors without wetting. Fuel Process. Technol. 2007;88(5):501-11.
  12. Wang D, Teo W, Li K. Removal of H2S to ultra-low concentrations using an asymmetric hollow fibre membrane module. Sep. Purif. Technol. 2002;27(1):33-40.
  13. Ze Z, Sx J. Hollow fiber membrane contactor absorption of CO2 from the flue gas: review and perspective. Glob. Nest. J. 2014;16:355-74.
  14. Park H-H, Lim C-W, Jo H-D, Choi W-K, Lee H-K. Absorption of SO2 using PVDF hollow fiber membranes with PEG as an additive. Korean J. Chem. Eng. 2007 2007/07/01;24(4):693-7.
  15. Sun X, Meng F, Yang F. Application of seawater to enhance SO2 removal from simulated flue gas through hollow fiber membrane contactor. J. Mem. Sci. 2008 2008/04/01/;312(1):6-14.
  16. Zhang Z, Yan Y, Wood DA, Zhang W, Li L, Zhang L, et al. Influence of the Membrane Module Geometry on SO2 Removal: A Numerical Study. Ind. Eng. Chem. Res. 2015 2015/11/25;54(46):11619-27.
  17. Wu S, Uddin MA, Su C, Nagamine S, Sasaoka E. Effect of the Pore-Size Distribution of Lime on the Reactivity for the Removal of SO2 in the Presence of High-Concentration CO2 at High Temperature. Ind. Eng. Chem. Res. 2002 2002/10/01;41(22):5455-8.
  18. Cheng C, Zhang H, Chen H. Experimental study on water recovery and SO2 permeability of ceramic membranes with different pore sizes. Inter. J. Energ. Res. 2020;44(8):6313-24.
  19. Noei S, Mahdavian M. Modeling and Simulation of SO2 removal from flue gas using membrane contactor. Iranian J. Mar. Technolo. 2018;5(1):45-53.
  20. Vaez M, Zarringhalam Moghaddam A, Alijani S. Optimization and Modeling of Photocatalytic Degradation of Azo Dye Using a Response Surface Methodology (RSM) Based on the Central Composite Design with Immobilized Titania Nanoparticles. Ind. Eng. Chem. Res. 2012 2012/03/21;51(11):4199-207.
  21. Lee H-K, Jo H-D, Choi W-K, Park H-H, Lim C-W. Absorption of SO2 in hollow fiber membrane contactors using various aqueous absorbents. Desalination (Amsterdam). 2006;200(1-3):604-5.
  22. Jeon H, Ahn H, Song I, Jeong H-K, Lee Y, Lee H-K. Absorption of sulfur dioxide by porous hydrophobic membrane contactor. Desalination. 2008;234(1-3):252-60.
  23. Luis P, Garea A, Irabien A. Sulfur dioxide non‐dispersive absorption in N, N‐dimethylaniline using a ceramic membrane contactor. J. Chem. Technol. Biotechnol. Int. Res. Process Environ. Clean Technol. 2008;83(11):1570-7.
  24. Luis P, Garea A, Irabien A. Zero solvent emission process for sulfur dioxide recovery using a membrane contactor and ionic liquids. J. Mem. Sci. 2009;330(1-2):80-9.
  25. Royaee SJ, Sohrabi M, Fallah N. A comprehensive study on wastewater treatment using photo-impinging streams reactor: Continuous treatment. Korean J. Chem. Eng. 2012 2012/11/01;29(11):1577-84.
  26. Abdullah AH, Moey HJM, Yusof NA. Response surface methodology analysis of the photocatalytic removal of Methylene Blue using bismuth vanadate prepared via polyol route. J. Environ. Sci. 2012 2012/09/01/;24(9):1694-701.
  27. Fasihi M, Shirazian S, Marjani A, Rezakazemi M. Computational fluid dynamics simulation of transport phenomena in ceramic membranes for SO2 separation. Math. Comput. Model. 2012;56(11-12):278-86.
  28. Chong MN, Jin B, Chow CWK, Saint CP. A new approach to optimise an annular slurry photoreactor system for the degradation of Congo Red: Statistical analysis and modelling. Chem. Eng. J. 2009 2009/10/01/;152(1):158-66.
  29. Karoor S, Sirkar KK. Gas absorption studies in microporous hollow fiber membrane modules. Ind. Eng. Chem. Res. 1993 1993/04/01;32(4):674-84.
  30. Lv Y, Yu X, Tu S-T, Yan J, Dahlquist E. Experimental studies on simultaneous removal of CO2 and SO2 in a polypropylene hollow fiber membrane contactor. Appl. Energy. 2012 2012/09/01/;97:283-8.
  31. Naim R, Ismail A. Effect of fiber packing density on physical CO2 absorption performance in gas–liquid membrane contactor. Sep. Purif. Technol. 2013;115:152-7.
آمار
تعداد مشاهده مقاله: 450
تعداد دریافت فایل اصل مقاله: 475


سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب