پیوندهای مفید
اخبار و اعلانات
آمار
| تعداد نشریات | 158 |
| تعداد شمارهها | 6,226 |
| تعداد مقالات | 67,700 |
| تعداد مشاهده مقاله | 115,008,665 |
| تعداد دریافت فایل اصل مقاله | 89,690,440 |
Flexural Behavior of Lightweight Concrete Beams Reinforced with GFRP Bars and Effects of the Added Micro and Macro Fiber | ||
| Civil Engineering Infrastructures Journal | ||
| مقاله 10، دوره 52، شماره 2، اسفند 2019، صفحه 349-363 اصل مقاله (1.41 M) | ||
| نوع مقاله: Research Papers | ||
| شناسه دیجیتال (DOI): 10.22059/ceij.2019.277143.1557 | ||
| نویسندگان | ||
| Seyed Ehsan Vakili* 1؛ Peyman Homami2؛ M. R. Esfahani3 | ||
| 1Civil engineering, kharazmi university, Tehran,Iran | ||
| 2Department of Civil Engineering, Kharazmi University, Tehran, Iran | ||
| 3Department of civil engineering, Ferdowsi university of Mashhad, Mashhad, Iran | ||
| چکیده | ||
| This study evaluated the effect of macro steel fiber (SF), micro glass fiber (GF) and micro polypropylene fiber (PF) in lightweight aggregate concrete, (LWAC) beams reinforced with glass fiber reinforced polymer (GFRP) bars. Firstly, concrete mixtures with different volume fractions of GF, PF and SF were tested up to compressive strength, then determine the optimum fiber content GF, PF and SF added into LWAC mix by 0.3%, 0.8% and 0.25% by the volume of concrete, respectively. Meanwhile, eight rectangular cross-section beams with 100 mm (width) × 200 mm (depth) × 1500 mm (length) were tested by four-point bending beam test up to the ultimate load. The GFRP bars were used to reinforce all beams. The failure modes, load-deflection behavior, ductility, flexural capacity and energy absorption were compared in the test results. The experimental results shown added fibers into LWAC improved the flexural capacity, ductility and energy absorption also enhanced moment capacity by 10.07% to 110%. The results indicated that failure modes of GF and PF specimens were in good consistency with the ACI 440.1R-06 predicted failure modes, but for SF specimens, only concrete crushing failure modes accrued. At the end step, the correction factor ( ) obtained from calculated of the experimental results with the flexural capacity according to the ACI 440.1R-06 and ISIS design manual No. 3. | ||
| کلیدواژهها | ||
| GFRP Bar؛ Lightweight Aggregate Concrete؛ Macro Steel Fiber؛ Micro Glass Fiber؛ Micro Polypropylene Fiber | ||
| مراجع | ||
|
American Concrete Institute (ACI). (2003).Guide for structural lightweight-aggregate concrete, ACI 213R–03 Farmington Hills, MI.
American Concrete Institute. Committee 440. (2006), Guide for the design and construction of structural concrete reinforced with FRP bars, ACI 440.1 R-06.
ASTM Standard (2015), Standard test method for slump of hydraulic-cement concrete, ASTM Annual Book of ASTM Standards C143.
Badogiannis, E.G., Christidis, K.I. and Tzanetatos, G.E. (2019). “Evaluation of the mechanical behavior of pumice lightweight concrete reinforced with steel and polypropylene fibers”, Construction and Building Materials, 196, 443-456.
Bilodeau, A., Kodur, V.K.R. and Hoff, G.C. (2004). “Optimization of the type and amount of polypropylene fibers for preventing the spalling of lightweight concrete subjected to hydrocarbon fire”, Cement and Concrete Composites, 26(2), 163-174.
Bogas, J.A. and Gomes, A. (2015). “Non-steady-state accelerated chloride penetration resistance of structural lightweight aggregate concrete”, Cement and Concrete Composites, 60, 111-122.
Campione, G. and La Mendola, L. (2004). “Behavior in compression of lightweight fiber reinforced concrete confined with transverse steel reinforcement”, Cement and Concrete Composites, 26(6), 645-656. Chen, B. and Liu, J. (2005). “Contribution of hybrid fibers on the properties of the high-strength lightweight concrete having good workability”, Cement and Concrete Research, 35(5), 913-917. Choi, J., Zi, G., Hino, S., Yamaguchi, K. and Kim, S. (2014). “Influence of fiber reinforcement on strength and toughness of all-lightweight concrete”, Construction and Building Materials, 69, 381-389. Domagała, L. (2011). “Modification of properties of structural lightweight concrete with steel fibres”, Journal of Civil Engineering and Management, 17(1), 36-44. Guler, S. (2018). “The effect of polyamide fibers on the strength and toughness properties of structural lightweight aggregate concrete”, Construction and Building Materials, 173, 394-402.
Hamoush, S., Abu-Lebdeh, T. and Cummins, T. (2010). “Deflection behavior of concrete beams reinforced with PVA micro-fibers”, Construction and Building Materials, 24(11), 2285-2293. ISIRI (Institute of Standards and Industrial Research of Iran). (2000). Specification for Portland cement, ISIRI Number 389, 8th Edition. ISIS, D.M.N. (2007). “Reinforcing concrete structures with fiber reinforced polymers”, Intelligent Sensing for Innovative Structures Canada, Winnipeg.
Jun Li, J., Jun Wan, C., gang Niu, J., feng Wu, L. and chao Wu, Y. (2017). “Investigation on flexural toughness evaluation method of steel fiber reinforced lightweight aggregate concrete”, Construction and Building Materials, 131, 449-458. Kakizawa, T., Ohno, S. and Yonezawa, T. (1993). “Flexural behavior and energy absorption of carbon FRP reinforced concrete beams”, Special Publication, 138, 585-598. Kara, I., Ashour, A., Körog˘lu, A. (2015). “Flexural behavior of hybrid FRP/steel reinforced concrete beams”, Composite Structures, 129, 111–121.
Khaloo, A., Raisi, E.M., Hosseini, P. and Tahsiri, H. (2014). “Mechanical performance of self-compacting concrete reinforced with steel fibers”, Construction and Building Materials, 51, 179-186.
Lee, J.H., Cho, B. and Choi, E. (2017). “Flexural capacity of fiber reinforced concrete with a consideration of concrete strength and fiber content”, Construction and Building Materials, 138, 222-231. Li, J., Niu, J., Wan, C., Liu, X. and Jin, Z. (2017). “Comparison of flexural property between high performance polypropylene fiber reinforced lightweight aggregate concrete and steel fiber reinforced lightweight aggregate concrete”, Construction and Building Materials, 157, 729-736. Libre, N.A., Shekarchi, M., Mahoutian, M. and Soroushian, P. (2011). “Mechanical properties of hybrid fiber reinforced lightweight aggregate concrete made with natural pumice”, Construction and Building Materials, 25(5), 2458-2464. Lin, C., Kayali, O., Morozov, E.V. and Sharp, D.J. (2014). “Influence of fiber type on flexural behaviour of self-compacting fiber reinforced cementitious composites”, Cement and Concrete Composites, 51, 27-37.
Oktay, H., Yumrutaş, R. and Akpolat, A. (2015). “Mechanical and thermo physical properties of lightweight aggregate concretes”, Construction and Building Materials, 96, 217-225.
Omar, A., Ehab, A., Hamdy, M. and Brahim, B. (2019). “Flexural strength and serviceability evaluation of concrete beams reinforced with deformed GFRP bars”, Engineering Structures, 186, 282-296. Qian, C.X. and Stroeven, P. (2000). “Development of hybrid polypropylene-steel fiber-reinforced concrete”, Cement and Concrete Research, 30(1), 63-69.
Ramezani, A.R. and Esfahani, M.R. (2018). “Evaluation of hybrid fiber reinforced concrete exposed to severe environmental conditions”, Civil Engineering Infrastructures Journal, 51(1), 119-130.
Shafigh, P., Jumaat, M.Z., Mahmud, H.B. and Alengaram, U.J. (2011). “A new method of producing high strength oil palm shell lightweight concrete”, Materials and Design, 32(10), 4839-4843.
Standard BS (1983). Method for determination of compressive strength of concrete cubes concrete specimens, BS, 1881-116.
Tajra, F., Elrahman, M., Lehmann, C., Stephan, D. (2019). “Properties of lightweight concrete made with core-shell structured lightweight aggregate”, Construction and Building Materials, 205, 39-51.
Taly, N., Ganga, H.V. and Vijay, P.V. (2006). Reinforced concrete design with FRP composites, CRC press.
Tang, W.C., Balendran, R.V., Nadeem, A. and Leung, H.Y. (2006). “Flexural strengthening of reinforced lightweight polystyrene aggregate concrete beams with near-surface mounted GFRP bars”, Building and Environment, 41(10), 1381-1393. Vakili, S.E., Homami, P. and Esfahani, M.R. (2019). “Effect of fibers and hybrid fibers on the shear strength of lightweight concrete beams reinforced with GFRP bars”, In Structures, 20, 290-297, Elsevier. Wu, T., Yang, X., Wei, H., Liu. (2019). “Mechanical properties and microstructure of lightweight aggregate concrete with and without fibers”, Construction and Building Materials, 199, 526-539.
Yoon, J.Y., and Kim, J.H. (2019). “Mechanical properties of preplaced lightweight aggregates concrete”, Construction and Building Materials, 216, 440-449. Zhu, H., Cheng, S., Gao, D., Neaz, S.M. and Li, C. (2018). “Flexural behavior of partially fiber- reinforced high-strength concrete beams reinforced with FRP bars”, Construction and Building Materials, 161, 587-597. | ||
|
آمار تعداد مشاهده مقاله: 550 تعداد دریافت فایل اصل مقاله: 433 |
||