پیوندهای مفید
اخبار و اعلانات
آمار
| تعداد نشریات | 163 |
| تعداد شماره‌ها | 6,762 |
| تعداد مقالات | 72,842 |
| تعداد مشاهده مقاله | 131,925,857 |
| تعداد دریافت فایل اصل مقاله | 103,552,939 |
Assessment of the stress path and prediction of fault activity in oil reservoirs(Ahvaz oil field) | ||
| Geopersia | ||
| مقالات آماده انتشار، پذیرفته شده، انتشار آنلاین از تاریخ 20 اسفند 1403 اصل مقاله (1.9 M) | ||
| نوع مقاله: Research Paper | ||
| شناسه دیجیتال (DOI): 10.22059/geope.2025.385995.648789 | ||
| نویسندگان | ||
| Behroz Teimori1؛ Mehran Arian* 1؛ Mohammad Abdideh2؛ Ali Solgi1؛ Zahra Maleki1 | ||
| 1Department of Earth Sciences, Science and Research Branch, Islamic Azad University, Tehran, Iran | ||
| 2Department of Petroleum Engineering, Omidiyeh Branch,Islamic Azad University, Omidiyeh, Iran. | ||
| چکیده | ||
| Understanding fault conditions and slip behavior is essential throughout the lifespan of a reservoir. The formation of new gaps or faults within a reservoir significantly increases the costs and risks associated with drilling operations. This research examined the potential for fracture formation resulting from discharge and a reduction in pore pressure. Well drilling data from a reservoir in southwest Iran were used to calculate the principal stresses and develop a geomechanical model. Based on this model, the safe mud weight window for drilling was also determined. Finally, the potential for fracture formation was assessed throughout the reservoir's production phase. The results show that the mud loss pressure in the reservoir corresponds to the minimum horizontal stress value (σ3), with an average value of approximately 41.75 MPa. The stress regime in the reservoir is a normal (σv> σH> σh), and the safest drilling direction is parallel to the vertical stress. According to the results, the orientations of the minimum and maximum horizontal stresses are N16W-S16E and N74E-S74W, respectively, with a standard deviation of 6.5 degrees. As a result of the production and discharge of hydrocarbon reservoirs, the initial pore pressure decreases. The decrease in pore pressure causes a change in the effective stress and subsequently the in situ stress field, and this phenomenon will cause new fractures and faults in the reservoir. The formation of new faults due to reservoir discharge is more likely to occur in the sandstone layers of the studied reservoir compared to the limestone and dolomite layers. | ||
| کلیدواژه‌ها | ||
| Stress field؛ Fault؛ Pore pressure؛ Geomechanical model؛ Zagros | ||
|
آمار تعداد مشاهده مقاله: 127 تعداد دریافت فایل اصل مقاله: 68 |
||
سامانه مدیریت نشریات علمی. قدرت گرفته از سیناوب